How to modify a three-quarters to bed frame bed frame

With plywood, you can make a larger smaller image. An image of three-quarters mattress is a framework for single person to measure smaller diameter than a framework of complete bed can sleep two persons. Size mattress standard measure 54-inches wide and 75 inches long. You can use your framework of three-quarters of mattress and convert it into a framework capable of holding a box spring and mattress for bed size with a few basic supplies purchased at your home renovation retailer.Difficulty: moderately EasyTable sawTape measure1/4-inch diameter drilling bitHand drill1/4-inch machine screws1/4-inch boltsWrench set1

Cut a piece of plywood of 1 inch thick furniture quality with a saw to the dimensions of the mattress magnitude. Once, the standard size is 54 inches in width and 75 cm in length. However, measure your actual mattress with a tape measure first and use these measures for a specific adjustment. Plywood will be a top of basement for your bed frame.

2

Place the face to the plywood on the floor and then place the top of the bed on the plywood structure. Center of the frame of the bed from the top to bottom and from left to right. This evenly distribute the weight of the mattress and mattress on the framework.

3

Four holes pilots also spaced along the length of each rail on drilling bed frame. Drill holes while the framework of bed and plywood. Use a drill bit and drilling of 1/4 inch hand.

4

Place the framework of bed on his feet and then place the top of plywood on the bed frame. Align the mounting holes.

5

Push screws machine of 1/4 inch in diameter through holes at the top of plywood and same down if the holes in the bed of the rails framework. A nut 1/4 inch on the end of each thread bolt and then tighten the wheels with a set of key.

6

Place the box spring and mattress on the sheet of plywood.

Place a ruffle of dust on the sheet of plywood before you install in the spring of beds and mattresses will help hide the conversion.

Photo Credit Jupiterimages/BananaStock/Getty Images; Read more:

View the original article here

How to modify a quilt of the King to a Twin size

If you have a spare king size duvet or there is only a king available your quilt desired fit size, altering size comforter a twin is possible. Duvet hotel is 102 inches on 86, a twin is 68 inches on 86. Cutting the width of a comforter will create a twin size quilt.Difficulty: moderately Easy1

File your quilt on a flat surface. Work with the full size pyramid will make the process faster.

2

Measure the dimensions of the comforter to determine the width and length. The width will measure more than length.

3

Measure 69 inches in width and mark it with a piece of adhesive tape. Ribbon will be spot not the comforter, as would a permanent marker.

4

Place the vertical band on the area that you have marked previously, that extends from one end to the other.

5

Cut along the edge of the band with scissors sewing. Move carefully to reduce the straying away from the edge of the band.

6

Remove a half-inch of the cotton on the side. Use the scissors for this process to reduce inequality.

7

Fold the raw edges inward one-third of an inch, forming a fold. This hide rough edges and give the comforter sewing a finished look.

8

Initiate a process of weaving from the upper part of the comforter freshly cut with your sewing needles. Paste your thread through the needle hole sewing and tie a knot. Paste the needle through the two ends of the edge cut of the comforter and remove the needle through to create a mesh. Continue to stitch the comforter, avoiding cotton.

Read more:

View the original article here