Sunday, October 2, 2011

How to modify a three-quarters to bed frame bed frame

How to Change a Three-Quarter Bed Frame to Full Bed Framethumbnail With plywood, you can make a larger smaller image. An image of three-quarters mattress is a framework for single person to measure smaller diameter than a framework of complete bed can sleep two persons. Size mattress standard measure 54-inches wide and 75 inches long. You can use your framework of three-quarters of mattress and convert it into a framework capable of holding a box spring and mattress for bed size with a few basic supplies purchased at your home renovation retailer.Difficulty: moderately EasyTable sawTape measure1/4-inch diameter drilling bitHand drill1/4-inch machine screws1/4-inch boltsWrench set1

Cut a piece of plywood of 1 inch thick furniture quality with a saw to the dimensions of the mattress magnitude. Once, the standard size is 54 inches in width and 75 cm in length. However, measure your actual mattress with a tape measure first and use these measures for a specific adjustment. Plywood will be a top of basement for your bed frame.

2

Place the face to the plywood on the floor and then place the top of the bed on the plywood structure. Center of the frame of the bed from the top to bottom and from left to right. This evenly distribute the weight of the mattress and mattress on the framework.

3

Four holes pilots also spaced along the length of each rail on drilling bed frame. Drill holes while the framework of bed and plywood. Use a drill bit and drilling of 1/4 inch hand.

4

Place the framework of bed on his feet and then place the top of plywood on the bed frame. Align the mounting holes.

5

Push screws machine of 1/4 inch in diameter through holes at the top of plywood and same down if the holes in the bed of the rails framework. A nut 1/4 inch on the end of each thread bolt and then tighten the wheels with a set of key.

6

Place the box spring and mattress on the sheet of plywood.

Place a ruffle of dust on the sheet of plywood before you install in the spring of beds and mattresses will help hide the conversion.

Photo Credit Jupiterimages/BananaStock/Getty Images; Read more:

View the original article here

No comments:

Post a Comment