How to Fix Vibrations on Kenmore Front-Loader Washers

Although most Kenmore front-loader washers contain at least two springs to isolate vibration, your unit may still vibrate during a washing cycle if it isn't properly set up or maintained. Vibrations can be annoying and can diminish your washer's performance, so it's important to solve this problem when it arises. Vibrations are generally caused by leveling problems. When the washer is unbalanced, it begins to rattle during washing cycles. Checking the installation setup and making necessary adjustments may solve this problem.

Difficulty:Moderate14mm open-end wrench3/4-inch sheet plywood1

Check all four feet on your washer. If the lock nuts aren't tight against the washer cabinet, the washer may vibrate.

2

Adjust the four lock nuts on the washer feet with a 14mm open-end wrench. Check the levelness of the washer and, if necessary, adjust the height. If the washer rocks back and forth, or side to side, the washer isn't level. All four feet should be stable and resting on the floor.

3

Move the washer slightly from its cabinet, and then loosen the lock nuts if it's not level. Place a piece of 3/4-inch plywood underneath your washer to reduce noise and vibration. Adjust the feet as necessary, and then tighten the lock nuts.

Installation and setup instructions may vary with different Kenmore front-loader washers, so always refer to your manual.

Read Next:

View the original article here