How to replace the hardwood floor stair treads.

You can get quite a bit of the use and abuse of the hardwood flooring stair treads over several years after you install the. Relatively narrow stairway width for most, so this use is typically almost intact leaving gets lumped into the center of each tread. Will be able to solve problems of repair of worn tread not; only way. Fortunately, Exchange, capable of handling most homeowners is DIY work.. difficulties: ModerateSawhorseFlat pry barScrewdriverTape measureAngle finderPencilStraightedgeCircular sawConstruction adhesiveFinish nailsHammerNail setWood puttyPutty knife1

To prevent from trying to replace the stairs nobody is going to use it from the top of the stairs and block a Sawhorse tread faces.

2

Running the treads with a pry bar removes the baseboard. In the location pull wall Board form nails fixed points in and Board is secured.

3

Check to determine the connecting stairs treads. Find the top and bottom treads for any signs of nails or screws.

4

Treads where emptied all screws and drivers. Pry it from the slide position to glue along the front nails and flat pry bars, tread and stair riser steps. Press create your tread with any glue, to loosen the bonds between steps back a pry bar and move to wiggle. When reach points nailed all riser tread upward from stairs to apply the pressure. Tread corners procurement corruption to avoid the nail from the nail to work upon. Off the tread and pull down from step free tread.

5

Measure the old tread treads of the new hardwood, size determines the need. To measure the length and width of the tread to use a tape measure to [all angle viewfinder corner at an angle may have to cut each tread safe to fit your location on the step please establish.

6

Transfer and measuring angle of the new hardwood. Mark the cut may have appropriate fittings to tread new pencil and ruler. Circular saw marked walk along a line that cuts. Rear tread width instead remain without cutting front tread, step by step from taking next Stair risers against loss.

7

Test the required additional cuts to walk in new places, and to adjust the tread for perfect fit.

8

Applies to the zig-zag pattern line structural adhesives in step above. Hardwood tread riser back into a safe place to press firmly along for the place on the steps. Pressed the tread in place binding bonding time for 30-second step.

9

Finishing nails take steps to use the nail place all corners tread. Tread surface with Flash drive, hammer, nails, and nail set point Center onto the fingernail indents. Nail sets the top stair tread under little hits the nail hammer.

10

As long as the small hole on fingernails and toenails can be hidden near the tread colors entered the wood PuTTY. Holes in the popular PuTTY using a small putty knife, and is along the top of the tread knife blade scraping levels off.

11

Repeat the replacement in the tread of each step, stair along wall baseboards to replace.

Please read the following:

View the original article here